Superior Quality Dana 44 Spindles Available For Gm &Amp; Ford At Durasolid

Superior Quality Dana 44 Spindles available for GM & Ford at Durasolid

by

Kevin Hoffman

——————————————————————————————————————-

Spindles are the parts where the hub is attached and rotates on the spindle. Thus the spindles need to be resistant to wear and tear. Dana 44 spindles fitting in Ford 1977 -1979 F250 are available with Durasolid. These spindles feature internal locking hubs. There are 5 holes in the dana 44 spindles for Ford that have a stub axle of 9.72 inches. The total length is 6.21 and flange diameter is 6.12 inches. They are made out of high quality alloy steel and have increased strength to avoid wear and tear. Durasolid also manufactures spindle dana 44 for small bearings having ton disc brakes applications. There are 5 holes for a perfect fit into the hub. This will fit the ford models from 1976-1979 with F150/F100 series.

Durasolid is the leading manufacturer of the best quality dana 44 spindles. Contact immediately for more information.

Durasolid also manufactures Dana 44 Spindles for GM. There are Dana 44 Spindles or small bearings ton disc brakes applications. They are suitable for and fit 1973-1976 1/2 Chevy & GMC 1/2 ton, K 5 blazer jimmy & suburban, or even the 1974-1976 jeep Wagoneer& Cherokee 66-77 Ford Bronco. Dana 44 spindles for large bearing of ton are also available at Durasolid. They fit the 77 up Chevy/GM /Jeep. These 6 hole spindles weigh 7 lbs and are made of SAE 1541 alloy steel and are heat treated for an additional tensile strength. They are suitable for inner wheel bearings.

If you are looking for Dana 44 spindles for GM or Ford, Ford Spindles contact us to get the quality spindles. We guarantee the highest quality Dana 44 spindles for your GM & Ford vehicles.

Differential installers often face situations where after having set up the gears and replacing bearings they find that the shims under carrier bearings need to be changed to adjust the backlash. The conventional tools would end up in damaging the bearings or the seal surface and to save the same you have no choice but to live with the problem. Now the installers don t need to compromise or be afraid of damaging the carrier bearing if they own a Durasolid carrier bearing puller kit as the clamshell design won t let the bearings damage while pulling them out and also save your expensive differential locker or carrier from damaging. Differential Installers who could not afford to buy the Clam shell design bearing pullers used to get it on rent as high as $100. DURASOLID upon realizing this fact launched their clamshell design bearing puller in the range of $200.

Premium quality

dana 44 spindles

are available at Durasolid at the most competitive prices. We are the leading manufacturers of

ford spindles

,

dana 44

spindle made from alloy steel, for both the models GM & Ford.

Article Source:

ArticleRich.com